Instruction manual of EZM Programmable Counter consists of two main . EMKO Elektronik warrants that the equipment delivered is free from defects in. BUT it’s a negative number and I cannot figure out what to do? HELP PLEASE? EMKO ESM Temperature Controller-img_jpg. ESM, ESM, ESM, ESM, ESM ESM 8 mm. Green 4 EMKO Elektronik warrants that the equipment delivered is free from.
|Published (Last):||13 September 2006|
|PDF File Size:||8.88 Mb|
|ePub File Size:||2.45 Mb|
|Price:||Free* [*Free Regsitration Required]|
Can you shoot me a link or something to a hand held device I could purchase to use? If you have a electronic multimeter it may have an input for thermocouples. Results 1 to 9 of 9. eemko
So first thing you need to do is check the type of thermocouple you have I am technically challenged but could tell me how to test the thermocouple exactly? They have excellent customer service. You may fix it for sure. One you know what type you have you need to go into the controllers settings to see if it’s setup for that esm-440 of thermocouple.
It’s odd that its showing negative Originally Posted by fivestarcoffeeroasters. Obviously be careful you turn on your drum and its cold Hi dear I just read your post about toper drum tempreture. I own toper cafemino. Steve Green Mill City Roasters. Your thermocouple is likely disconnected or has a broken wire.
BUT it’s a negative number and I cannot figure out what to do?
Process Controllers – ESM/ | HTA Instrumentation (P) Ltd.
Yes the bottom value is setting the maximum temp it will reach before the gas gets cut off. Some temp controllers indicate a bad or disconnected thermocouple differently. I would hope that the manufacturer would tell you this.
ssm-4430 Brand new then contact Toper. But after using toper i discover they use J type thermocouple and honestly its very thick and gave low value for tempreture.
The time now is Emio for your help! Hello Fellow Roasters, we just received our Toper 15 kilo roaster from Turkey and could not be more excited to start roasting.
Can you reach the thermocouple inside of the drum? When you said ” check is to see if the thermocouple type is set properly in the controller” I would assume the bottom value that you are setting is the maximum temperature it will reach before esm-44300 off the gas valve fire esm4-430 feature. I use different thin thermocuple connected with Phidget Its the wiring problem you have to opposite the wire in behind the temperature controller.
The one in my older toper flashes the display at loss of continuity, the phidget shows a negative number.
How do I check this? You can test a thermocouple with a multimeter, it should read a emkk ohms, I would suggest a disconnected probe or bad connection at the controller? Second thing I would check is to see if the thermocouple type is set properly in the controller. If you take a look at the attached picture If you can may not be possible you could unplug the thermocouple from the controller and plug into esmm-4430 handheld device.
Charlie If you are afraid of failure or losing money, quit while you are ahead.
In my scenario I could route my cabling to this device when I was having issues I have the pre-set temp at but the top number should read the current temp of the drum All times are GMT